The paint is hypoallergic, so it doesn't affect irritating, skin-resorbing and sensitizing (allergic) reactions. It is remarkable for its coverage rate, high resistance level to repeated washing (1 class acc. to DSTU EN 13300) and vapor permeability. It creates the coating with silky-matt gloss. It contains vax, which provides a "lotus effect" as the coating achieves water repellent features and is easy to clean from contaminations from the surface. It is easy to apply, doesn't run and spray during application.
Acrylic latex, pigments, fillers, water, additives.
white (base A).
It is tinted manually with water-based color pastes "Farbex Color" or with tinting machines according to NCS color rate.
It is recommended to use the product of the same batch for coating of one surface to avoid deviation in shades. If you use the product of different batches it is necessary to mix them.
It is not recommended to dilute tinted paint for applying of finishing coat.
Insignificant deviations in the technical properties of the product are possible after tinting.
110-150 g/m2 It depends on the way of application
Water. It is allowed to delute the product up to 10% of the total mass of the product
Apply with a roller, a brush or a spraying gun
max. 1 hour. Drying period increases if the temperature is going down and relative air humidity is getting high
It can be tinted according to the NCS color rate
ab. 1,3 g/cm3
max. 10 GU at 60°, mid sheen, DSTU EN 13300)
max. 20 micron, (fine-grained, DSTU EN 13300)
min. 99%, 2 class of the coating rate (acc. to DSTU EN 13300)
max. 5 (after 200 cycles), 1 class of washing resistance (acc. to DSTU EN 13300)
36 months, (at the temperature from +5°С till +35 °С)
1,2 kg, 3,5 kg, 6 kg, 12 kg
The surface for coating shall be dry and hard, thoroughly cleaned from dust, chalk and lime coatings, fragile coats, grease and other dirt. Defects of the surface shall be removed with Plaster TM "Farbex".
Polish dried surface and remove abrasive dust. Treat the surfaces with antiseptic TM "Farbex" in wet and poor aired premises.
Treat the surface with a deep-penetrating primer TM "Farbex" or a concentrated primer 1:10 TM "Maxima" to harden the surface and equalize its adhesive ability.
Stir the product thoroughly before application.
Perform application at the temperature of air and the surface from + 10 °С till + 35 °С and relative air humidity less than 80%.
TOOLS AND THE QUANTITY OF COATS: Apply the paint with a brush, a roller or a spraying gun in 1-2 coats. Clean the tools with water thoroughly after application. Don't let the product dry on tools.
Clean tools with water after application. Do not let them dry. Dry product shall be removed from the tools in mechanical way.
This latex paint is recommended for initial and renovating coating of walls and ceilings in dry and wet premises with high exploitation loading: children's rooms, kindergartens, medical and educational establishments, living and administrative premises, trade and recreation establishments and industrial premises. It is not intended for coating floors, doors and furniture!
SPHERE OF APPLICATION: For interior works.
SURFACES: Mineral (plasters, stuccos, bricks, concrete), gypsum, wooden surfaces, wallpaper and fiberglass and the surfaces, which were previously coated with oil enamels.
Matt latex interior paint
Silky-matt latex interior paint
When you decide to renovate your house or flat there is not always a definite correct design of the renovation and an idea of definite materials...